Precision CC01 Tie Rods CC160 by GPM  [CC160]

Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160
Price:
USD$7.50
Brand:
GPM
Model:
CC160
GTIN:
4894538032147
Condition:
Brand New
Available in shop
Write a review
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"
alt="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160" title="Tamiya CC01 Alloy Tie Rod For Servo & Steering - 3pcs set - GPM CC160"

Precision tie rod set for CC01

This 3pcs tie rod set is presented as a metal upgrade for Tamiya CC01 servo and steering linkages, intended to replace plastic link rods and provide a firmer reference for geometry adjustments in hobby builds.

The three-piece pack covers common steering connections and installs as a direct replacement using existing CC01 linkage hardware and mounting points where compatible. The design focuses on consistent fit and repeatable alignment rather than additional components.

For setup and tuning, metal tie rods give a stable baseline for toe and steering end-point calibration, which helps maintain alignment through repeated runs. During installation, inspect threaded engagement carefully, secure fittings to the recommended tightness, and verify smooth, unrestricted steering arm movement after assembly.

This item is compatible with

  • TAMIYA CC01

What does the 3pcs pack include?

The package contains three tie rods intended to replace typical CC01 steering linkages and cover common connection points on the chassis.

Is any trimming or rework required for fitment?

No trimming is normally required; these parts are designed as a direct swap into CC01 steering assemblies using existing hardware where compatible.

How should I check alignment after install?

After fitting, confirm thread engagement and torque, then check toe and steering endpoints on a level surface to ensure alignment remains consistent under load.