Precision Aluminium Servo Mount and Linkage Upgrade TXM024N by GPM  [TXM024N]

CNC machined 6061-T6 servo mount for X-MAXX

This TXM024N kit from GPM provides a CNC-focused upgrade path for TRAXXAS X-MAXX steering servo mounts, allowing servos that share the 2075x footprint to be mounted with superior rigidity. Machined 6061-T6 components replace stamped or plastic parts to reduce deflection and preserve steering geometry under high loads.

The supplied hardware set covers the machined servo mount, a single aluminium tie rod, a 25T aluminium servo horn, a range of stainless fasteners in multiple lengths, and small shims to fine-tune preload and horn centring. Components are engineered to align with stock mount locations when the target servo matches the original 2075x bolt pattern.

Installation guidance for technicians: precisely measure servo case height and bolt spacing, maintain correct horn indexing with the supplied shims, and apply controlled torque values to cap-head screws when fastening aluminium-to-aluminium joints to avoid thread deformation. After installation, verify steering endpoints and recheck torque after initial runs.

Intended tuning role: deploy this kit to reduce steering flex and improve repeatability when upgrading to higher torque metal-geared servos on 8S platforms; expect more consistent steering geometry during dynamic loads which aids precise setup and handling.

The TXM024N delivers a direct aluminium replacement for common TRAXXAS X-MAXX servo mount points, engineered for durability and alignment with included hardware.