Precision Aluminium Rear Arm Bulk for 1/18 Latrax Rally LTX009 by GPM  [LTX009]

TRAXXAS 1/18 Latrax Rally Aluminium Rear Arm Bulk - 1pc - GPM LTX009
Price:
USD$9.90
Brand:
GPM
Model:
LTX009
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium rear arm bulk for Latrax Rally 1/18

This aluminium rear arm bulk is an aftermarket replacement designed to fit the TRAXXAS 1/18 Latrax Rally and is supplied as one 1pcs unit. The alloy construction provides a more robust substitute for the stock plastic part while preserving factory mounting points for direct fitment.

Installation procedure for experienced hobbyists: remove the original rear arm bulk, transfer linkage hardware and bearings as needed, orient the alloy unit correctly and secure with the original mounting screws. After installation confirm secure fastener engagement and full, unobstructed suspension articulation.

From a tuning perspective the aluminium bulk will affect rear suspension attachment stiffness and durability; factor this into any changes to shock setup or rear geometry. This component is sold as an aftermarket replacement intended for RC use only.

What should I check before fitting?

Verify the chassis mounting holes and linkage spacing match the listed TRAXXAS 1/18 Latrax Rally pattern and retain original hardware where appropriate.

Is any special lubrication required?

No special lubrication is required for the alloy part itself, but ensure bearings and pivot points are clean and lightly greased according to normal RC maintenance practice.

How should I inspect fitment after installation?

Check that all screws are correctly torqued, confirm rear linkages move freely through full travel, and run a short test to confirm handling and alignment remain correct.