Mini-Z AWD Precision Delrin Ridge Rims 6pcs 0mm Offset 8.3mm DMZA601FR888 by GPM  [DMZA601FR888]

GPM DMZA601FR888 technical overview

The DMZA601FR888 set provides matched front and rear Delrin ridge-style rims delivered with pre-mounted tyres, intended for Mini-Z AWD platforms. The item lists a 6pcs fastening pattern, 0mm offset and an 8.3mm rim width, supplied as a single paired unit for tuning and track work. These nominal dimensions are chosen to integrate with typical Mini-Z AWD wheel assemblies for predictable fit and performance.

Fit and compatibility: specified for use with Kyosho Mini-Z AWD chassis. Verify wheel hex size and hub spacing relative to the 0mm offset and 8.3mm width before installation to confirm clearance with MR-03 AWD or comparable hubs and suspension geometry.

Installation and setup notes: Delrin rims install via press-fit onto standard 6-point Mini-Z AWD hubs and arrive with tyres pre-mounted. After fitting, perform a static spin and truing check to confirm minimal runout. Adjustments to rim width or offset will change scrub radius and track width; use short test runs to quantify handling changes prior to altering suspension or mass distribution.

Tuning considerations: at model scale Delrin offers low rotating mass and consistent stiffness, supporting repeatable cornering behaviour and weight transfer. Combine these rims with appropriate tyre inserts or rubber compounds for the running surface to fine-tune lateral grip and steering balance without modifying motor or ESC settings.