Mini-Z AWD Delrin Ridge Wheelset 5p 0mm 8.3mm DMZA601RW+1.5 by GPM  [DMZA601RW+1.5]

Mini-z AWD Delrin Front/Rear Ridge Rims (5p, 0mm Off set , Width 8.3mm) With Tires - 1pr set - GPM DMZA601RW+1.5
Price:
USD$6.80
Brand:
GPM
Model:
DMZA601RW+1.5
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview

Front and rear Delrin ridge rims produced for Kyosho Mini-Z AWD platforms and supplied as a one pair set (1pr set) including tyres. The geometry is 5p with 0mm offset and an 8.3mm nominal width, and the Delrin material is selected for dimensional stability under typical RC running conditions.

These rims provide two practical uses: direct replacement of worn Mini-Z AWD wheels, and a tuning component where rim material and track width affect handling. The Delrin compound reduces rotating mass while preserving a precise shaft-to-hub interface, and the ridge bead form promotes repeatable tyre seating for predictable lateral response.

Installation follows standard wheel hex mounting on stock Mini-Z AWD hubs. Confirm hub compatibility and clearances on MR-03 AWD and other Mini-Z AWD variants, and perform tyre balancing where required for repeatable high-speed performance. These components are intended solely for scale RC applications.

What components are supplied in the set?

One pair set including front and rear Delrin ridge rims with tyres fitted, supplied as a complete 1pr set for Mini-Z AWD.

How does Delrin affect handling?

Delrin offers stable dimensional behaviour and low rotating mass, which contributes to consistent tyre contact and predictable handling across repeated runs.

Fitment and setup recommendations?

Ensure proper hex engagement and check for body or suspension clearance. Balance tyres for competition or high-speed layouts and verify secure mounting before each session.