MF01X Steering Linkage Aluminium Completed 6pcs Upgrade - MF160 by GPM  [MF160]

Tamiya MF01X Aluminium Completed Tie Rod - 6pcs set - GPM MF160
Price:
USD$11.90
Brand:
GPM
Model:
MF160
GTIN:
4894538086706
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium tie rod assemblies for MF01X

This 6-piece set of completed aluminium tie rods is produced for fitment on MF01X-compatible steering systems and is supplied assembled for immediate installation. Each rod is prebuilt to replace worn or plastic linkages and to restore consistent steering geometry across the front end.

The aluminium construction provides reduced flex compared with common plastic components, improving repeatability after impacts and supporting accurate toe adjustments during setup procedures.

Installation procedure: remove the existing tie rods from the steering assembly and install the completed aluminium rods into the original mounting points. Check steering travel and toe alignment after fitting, and perform small incremental changes when tuning to validate handling behaviour.

Workshop role: fit the full 6pcs set to eliminate uneven play, refresh multiple link points in one service operation, or to stabilise steering response as part of routine performance maintenance.

What does completed assembly include?

Completed assembly means each tie rod comes preassembled with its end fittings and is ready to be installed without additional component assembly.

How do these affect steering geometry retention?

The stiffer aluminium links reduce elastic deformation under load, which helps the steering geometry stay closer to the setup values after impacts or heavy use.

Any special checks after fitting multiple rods?

After fitting multiple rods, confirm symmetry on both sides, re-centre the steering servo, and perform controlled test runs to fine tune toe and travel before full-speed operation.