MF01X Precision Spring Steel Completed Tie Rod Set MF160S by GPM  [MF160S]

Completed tie rod set for MF01X

The MF160S is a 6pcs completed tie rod set engineered as an aftermarket replacement for the Tamiya MF01X chassis. Each link is supplied assembled to minimise teardown time during maintenance and to allow fast replacement of fatigued or damaged links without disassembling ball ends or reworking linkage assemblies.

Technical note: shafts are formed from spring-grade steel to resist permanent deformation while offering a predictable flex profile that assists chassis tuning. As a direct-fit accessory for MF01X mounting points, these rods are intended to preserve the original steering geometry when installed to factory locations.

Assembly guidance: install in the same manner as original parts, verify full thread engagement and correct locking method at each end, then confirm toe and steering centring. Adjustments at the rod ends produce small but precise changes to toe and steering response, so proceed incrementally and validate adjustments on the bench before dynamic testing.

Application: completed tie rods provide a pragmatic upgrade for consistent steering behaviour and rapid part swaps between test runs or events, restoring baseline handling where stock links have fatigued.