LOSI LMT Matched 13T/43T Transmission Bevel Gear Set LMT1200S by GPM  [LMT1200S]

TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S
Price:
USD$28.90
Brand:
GPM
Model:
LMT1200S
GTIN:
4894538374278
Condition:
Brand New
Write a review
alt="TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S" title="TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S"

Medium carbon steel bevel gear replacement for LMT transmissions

This medium carbon steel bevel gear set includes the 13T and 43T gears intended for front and rear transmission housings used on LOSI LMT 4WD solid axle monster trucks. The components are supplied as matched items to act as direct replacements for worn bevel gears and to restore reliable gear engagement within the original gearbox envelope.

Both gears are fabricated in medium carbon steel to provide balanced tooth strength and wear characteristics while preserving original geometry and ratio. The 13T/43T matched pair should be installed together to maintain correct mesh and drivetrain timing. This aftermarket set is compatible with the LOSI LMT models shown in the compatibility box.

Packing includes

  • Bevel gear set 13T/43T - 2pcs

Original Name / Part No:

LOS242040,LOS242042

Compatible Models

  • LOSI-1/8 LMT 4WD SOLID AXLE MONSTER TRUCK-LOS04022
  • LOSI-LMT SOLID AXLE MONSTER TRUCK-LOS04021
  • LOSI-TLR TUNED LMT SOLID AXLE MONSTE-LOS04027
  • LOSI-LMT 4WD SOLID AXLE MEGA TRUCK-LOS04024

Use the matched 13T/43T set to recover serviceability in LOSI LMT transmission housings, and perform a careful mesh and bearing assessment during assembly to ensure optimal driveline behaviour.

Are the 13T and 43T gears supplied as a matched set?

Yes, the 13T and 43T are paired and intended to be installed together in the front and rear transmission housings to maintain correct ratio and tooth engagement.

What material specification is used for these gears?

The gears are produced from medium carbon steel to balance tooth strength and wear resistance without altering gearbox geometry or ratio.

Is any special preparation required before fitting?

Inspect and, if necessary, renew bearings and seals, check housing faces for wear, set proper backlash, then run the gearbox by hand to confirm correct mesh prior to final assembly.

What parts are included in the package?

The package includes the matched bevel gear set 13T/43T supplied as two pieces for front and rear transmission replacement.