LOSI LMT 7075 Alloy Precision Steering Servo Mount Plate LMT024L by GPM  [LMT024L]

Precision steering servo mount for LOSI LMT

This 7075 alloy steering servo mount plate is a precision aftermarket upgrade engineered for LOSI LMT solid axle platforms. It replaces the factory mounting arrangement with a stiffer CNC-friendly profile to improve mechanical support where larger or higher-torque servos are used, reducing flex under load while preserving the LOSI LMT servo footprint and interface points.

Installation uses the supplied cap and flat head screws together with thin stainless shims to establish exact stack height and alignment. The plate locates on the factory servo area and retains the original servo footprint while providing enhanced anchor points; technicians should confirm spline alignment and horn clearance prior to final torque. The included shims allow fine positional tuning without chassis modification.

Tuning and service notes: account for servo mount height, horn throw and link geometry when fitting larger servos to prevent binding at full lock, and verify steering centring after installation. The alloy plate alters local stiffness characteristics so re-check steering endpoint, subtrim and dual-rate settings in the transmitter to restore the intended steering response and maintain predictable handling. Routine hardware torque checks are recommended for sustained high-load use.

Use this precision plate where a more rigid servo mounting solution is required for LOSI LMT solid axle models, and verify servo clearance and steering geometry during installation to maintain predictable handling.