Kyosho Motorcycle Rear Steel Gear SKM152 Technical Replacement by GPM  [SKM152]

Kyosho Motor Cycle Steel Rear Gear - 1pc - GPM SKM152
Price:
USD$13.90
Brand:
GPM
Model:
SKM152
GTIN:
4894538116519
Condition:
Brand New
Write a review

Aftermarket hardened rear gear for Kyosho motorcycle platforms

This hardened steel rear gear is supplied as 1 pcs and is presented as an aftermarket replacement compatible with Kyosho motorcycle RC platforms that share the same mounting geometry. It is intended to provide enhanced wear resistance compared with softer replacement materials.

The component is intended for drivetrain longevity tuning and testing alternate gear ratios to influence traction and acceleration. The steel construction maintains consistent tooth contact under repetitive load cycles, which helps preserve tooth geometry during extended running.

Installation aligns with the motorcycle's existing rear-gear mounting points and standard fasteners; accurately set tooth mesh and measure backlash after installation to ensure even load distribution and avoid premature wear. This item is for scale RC applications only and not for full-size vehicles.

How should I verify compatibility before fitting?

Compare the replacement gear's bolt pattern and outside diameter with your existing Kyosho part, and confirm shaft location and thickness match to ensure correct fitment.

What inspection steps reduce risk of accelerated wear?

Set correct backlash, inspect mating pinion for wear, and ensure bearings run freely. Recheck mesh after a short break-in and address any uneven contact patterns immediately.

Which running conditions benefit most from steel gearing?

Environments with frequent high torque load cycles, prolonged practice sessions, or competitive use can benefit from the added wear resistance and stable tooth engagement of a hardened steel gear.