Kyosho Motorcycle Front Wheel 5-Spoke KM628/5F by GPM  [KM628/5F]

Kyosho Motor Cycle Aluminium Front Wheel (5 Spoke) - 1pc - GPM KM628/5F
Price:
USD$22.90
Brand:
GPM
Model:
KM628/5F
GTIN:
4894538055573
Condition:
Brand New
Write a review

Precision Aluminium 5-Spoke Front Wheel

This aftermarket aluminium front wheel is intended for Kyosho motorcycle RC platforms and is supplied as a single component for replacement or setup refinement. It is specified for hobbyists focused on durability and consistent front-end behaviour.

The component is an aluminium five-spoke wheel delivered as one unit. Prior to installation, confirm hub bore and hex interface geometry on the target Kyosho chassis to ensure correct seating and alignment.

In tuning contexts the wheel functions as a direct replacement for worn front wheels and provides a consistent basis for experiments with wheel mass and balance that influence steering response.

Specifications

  • Item Kyosho Motor Cycle Aluminium Front Wheel (5 Spoke) - 1pcs
  • Material Aluminium
  • Model Number KM628/5F
  • Compatibility Kyosho Motor Cycle

Install this aluminium front wheel as a measured upgrade or replacement for Kyosho motorcycle models, confirming hub and hex compatibility to secure proper fit and predictable handling results.

What dimensional checks are recommended before fitting?

Measure hub bore, hex size and flange seating on the chassis; ensuring concentricity at the hub is essential for predictable steering and tyre wear.

Is any balancing required after tyre fitment?

Perform a static balance evaluation after fitting tyres; aluminium rims can reveal minor imbalance that is correctable with small weights or trim adjustments.

Will this wheel alter suspension tuning?

Additional unsprung mass at the front can change suspension response and damping feel; adjust suspension settings incrementally when using aluminium wheels.

What hardware is typically needed for conversion?

Some chassis require specific hexes or hub adapters to retain correct offset and preload; inspect existing mounting hardware and source compatible components where necessary.

How should I verify part identification?

Use the model number KM628/5F when cross-referencing documentation or ordering to confirm you have the intended front wheel spec and fitment profile.

Any recommended installation tips?

Ensure clean mating surfaces, torque fasteners to manufacturer guidance, and validate wheel runout after assembly to maintain steering precision.