Kyosho Motorcycle Front Shaft KM025F Precision Upgrade by GPM  [KM025F]

Kyosho Motor Cycle Aluminium Front Wheel Shaft - 1pc set - GPM KM025F
Price:
USD$1.00
Brand:
GPM
Model:
KM025F
GTIN:
4894538002348
Condition:
Brand New
Write a review

Precision front shaft for Kyosho motorcycle assemblies

This aluminium front wheel shaft is a machined replacement component intended for Kyosho motorcycle model front wheel assemblies. Supplied as 1 pcs, it functions as the rotating axle element that locates the front wheel and engages with the hub and bearing stack.

Workshop installation is straightforward: withdraw the front wheel, slide the shaft through the hub and any installed bearings, then secure using the original retaining hardware from the model. The component is designed to interface with existing hub hardware and 走珠軸承 where applicable, avoiding the need for alternate specialised components.

As an upgrade item the aluminium shaft improves structural stiffness and corrosion resistance relative to certain stock shafts, reducing deflection under lateral loads and maintaining consistent bearing seating for predictable wheel geometry during operation.

What inspection should be done after fitting?

Verify axial play and radial runout of the wheel, confirm bearings are seated evenly, and re-torque retaining hardware to the model maker's recommended values.

Which bearing types are compatible?

Compatible with common sealed and open bearings that match the shaft diameter; ensure the internal bearing bore corresponds to the shaft for correct preload and seating.

Recommended checks for race preparation?

Check bearing condition, confirm no axial movement, and inspect hub interfaces for wear; replace bearings or spacers as needed to maintain repeatable alignment.