Kyosho Motorcycle Aluminium Rear Wheel Holder KM888 Precision Upgrade by GPM  [KM888]

Precision aluminium rear wheel holder for Kyosho applications

The KM888 aluminium rear wheel holder is presented as a single-set, RC-scale replacement and hop-up for Kyosho motorcycle models. Manufactured to serve as a rigid rear wheel mounting point, the component secures the wheel assembly for accurate setup, maintenance tasks, and higher-load running conditions.

Engineered for Kyosho motorcycle chassis that accept a bolt-on rear wheel support, this holder focuses on maintaining accurate axle alignment while streamlining wheel removal and reassembly. The aluminium construction improves resistance to plastic deformation and provides consistent mounting surfaces for repeatable setup checks.

Installation guidance: this holder replaces the stock rear wheel mount and installs using the vehicle's existing mounting points and hardware. Confirm original mounting geometry prior to fitment, ensure correct thread engagement, and apply threadlocker where specified. Typical RC workshop tools are sufficient for fitting and adjustment.

Tuning and service applications: use the KM888 when a fixed wheel location is required for setup validation, bearing replacement, or when suspension tuning increases loads on the wheel mounts. As an aftermarket aluminium upgrade it delivers a durable, precise alternative to original components without modifying wheel geometry.