KYOSHO Mini-Z AWD Rear Wide Delrin Ridge Rim DMZA601RW+1.0 by GPM  [DMZA601RW+1.0]

Mini-z AWD Delrin Rear Wide Ridge Rims (6p, 1.0mm Off set , Width 11mm) - 1pr - GPM DMZA601RW+1.0
Price:
USD$6.80
Brand:
GPM
Model:
DMZA601RW+1.0
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview of the Delrin rear wide rim

GPM model DMZA601RW+1.0 is a Delrin rear rim specified for KYOSHO Mini-Z AWD applications. The rim uses a six-point mounting interface, 1.0mm outward offset and an 11mm rim width to maintain correct clearance and wheel geometry for Mini-Z AWD rear hubs.

Installation follows standard Mini-Z practices: remove the existing rear wheel, align the six-point interface precisely and secure with the original fasteners. Verify radial runout and tyre seating after fitting to ensure consistent behaviour across runs.

From a setup standpoint this rim modestly increases rear track and modifies the contact patch, which can be used to tune rear grip and rotation on carpet and small-scale layouts. Implement changes in small increments and document setup differences for repeatable performance adjustments.

What material characteristics are important for this rim?

Delrin provides good dimensional stability and wear resistance for scale wheel applications. It resists deformation under normal race loads but should be inspected for wear when run on abrasive surfaces.

Any fitment tolerances to check during installation?

Ensure the six-point hub engages fully and that axial play is within expected limits. Check that the 1.0mm offset keeps the tyre clear of suspension and body mounts throughout travel.

Recommended maintenance and inspection?

Inspect for wear at the bead seat and mounting faces, confirm fastener torque after initial runs, and replace rims if excessive wear or deformation appears to maintain consistent handling.