Kyosho Mini Inferno Precision Motor Pinion 12T Aluminium MIF012T - 1pc by GPM  [MIF012T]

Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T
Price:
USD$1.50
Brand:
GPM
Model:
MIF012T
GTIN:
4894538096088
Condition:
Brand New
Write a review
alt="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T" title="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T"
alt="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T" title="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T"
alt="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T" title="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T"
alt="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T" title="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T"
alt="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T" title="Kyosho Mini Inferno Alloy Motor Gear (12T) - 1pc set - GPM MIF012T"

Precision 12T Aluminium Pinion for Mini Inferno

This single 12T aluminium-alloy motor gear serves as a precision replacement pinion for Kyosho Mini Inferno models, aimed at tuners and hobbyists seeking consistent engagement and predictable drive ratio changes on 1/10 electric platforms.

The aluminium-alloy construction noted in the listing prioritises a uniform tooth profile and stable mesh behaviour in typical use. Verify motor shaft dimensions and the pinion retention style before installation to ensure correct seating and to protect the mating spur gear from undue wear.

Recommended procedure: isolate power, remove or access the motor, fit the 12T pinion to the motor shaft, set minimal non-binding mesh, secure the set screw, and complete a controlled low-speed verification to confirm smooth engagement on the track.

What shaft sizes are compatible with this pinion?

Check your motor shaft diameter and the pinion bore. This pinion is intended for common hobby motor shafts; confirm mounting type to ensure proper fit.

How should I set and verify mesh?

Adjust mesh to a small clearance that avoids binding, tighten the set screw, then run a low-speed check. Reinspect after the initial session and retighten fasteners if necessary.

Is this pinion suitable for upgrading final drive ratios?

Yes, the 12T tooth count allows tuning of final drive behavior on 1/10 electric Mini Inferno setups; change pinion size in small increments and test to assess handling and motor load.