Kyosho Mini Inferno Precision Delrin Motor Pinion 15T DMIF015T by GPM  [DMIF015T]

Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T
Price:
USD$1.50
Brand:
GPM
Model:
DMIF015T
GTIN:
4894538045147
Condition:
Brand New
Write a review
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"

Precision 15T Delrin pinion for Mini Inferno applications

The DMIF015T Delrin 15-tooth motor gear is supplied as an aftermarket pinion for Kyosho Mini Inferno models and is intended for direct replacement and fine ratio tuning. The design focuses on consistent tooth profile and dimensional stability to maintain predictable mesh under typical model loads.

Delrin material offers low friction and stable dimensions during normal operation, supporting both common brushed and brushless motor installations in Mini Inferno vehicles. During assembly, verify correct axial alignment and gear mesh, secure the set screw to recommended torque, and confirm the drivetrain rotates freely before extended use.

Use this pinion for scheduled maintenance or incremental tuning between adjacent tooth counts to refine acceleration versus top speed. Check mesh with a thin shim when necessary and re-evaluate after an initial break-in run. This component is supplied as an RC model accessory and should be installed following standard workshop procedures.

What inspection steps ensure correct fit?

Confirm motor shaft diameter and grub screw position, set preliminary mesh with a thin paper shim, tighten the motor mount, then rotate the drive train to detect binding or misalignment.

How does material choice affect wear?

Delrin offers low friction and dimensional stability which helps maintain tooth engagement and reduces uneven wear when mesh and alignment are correct.

Recommended tuning procedure?

Make small changes in tooth count, document results, verify mesh after each swap, and conduct a short run-in to confirm temperature and noise remain within expected bounds.