Kyosho Mini Inferno Front Damper Plate GMIF028 - Precision Replacement by GPM  [GMIF028]

Front graphite damper plate

This front damper plate is produced for Kyosho Mini Inferno platforms and listed as GMIF028. It is a graphite replacement part intended for the front damper mounting location and is supplied with the mounting screws referenced in the original listing. The component interfaces with the stock front suspension tower and standard shock eyelet hardware used on Mini Inferno and Mini Inferno 09 chassis.

The plate functions as a direct replacement for worn or damaged damper mounts and as a straightforward tuning option where a firmer or lighter mounting surface is beneficial. Graphite offers a balance of stiffness and reduced mass compared with many plastics, resulting in modest changes to front-end response without altering suspension geometry.

Installation follows standard Mini Inferno service procedures: remove the existing front damper plate, transfer or fit the supplied screws, align the plate to the shock tower and shock eyelets, then tighten. Use the correct hex driver to prevent damage to screw heads and verify thread engagement during reassembly. No specialised tooling beyond common RC hand tools is required.