Kyosho Mini Inferno Alloy Rear Lower Arm Technical MIF056 by GPM  [MIF056]

Alloy rear lower arm for Mini Inferno platforms

This alloy rear lower arm is provided as an aftermarket replacement for Kyosho Mini Inferno and Mini Inferno 09 chassis and includes pivot pins, Delrin collars and E-clips as supplied. It retains the original mounting geometry to allow direct replacement of the stock plastic arms while offering the distinct wear and feedback characteristics of an alloy link.

Intended use: upgrade the rear lower link where increased abrasion resistance and firmer feedback are desired. The Delrin collars act as low-friction spacers on the pivot pins and the E-clips secure the assembly. As with any material change, confirm hole spacing on the vehicle and check for clearance before completing the installation.

Assembly notes: remove the rear hub assembly to access the lower arm pivot, install or transfer the supplied pins and collars, then fasten with the E-clips. Verify suspension travel and hub clearance after fitting to ensure there is no binding. Adjust rear spring and shock settings if needed to account for the slight change in unsprung mass and dynamic response.