HPI Savage 21 Anti-roll Bar Ball Ends SAV1311/BE by GPM  [SAV1311/BE]

HPI Savage 21 Plastic Ball Ends With Ball For Anti-roll Bar - 1pr set - GPM SAV1311/BE
Price:
USD$3.90
Brand:
GPM
Model:
SAV1311/BE
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview of SAV1311/BE anti-roll ball ends

The SAV1311/BE components are engineered as direct-fit plastic ball ends and mating balls for HPI Savage 21 anti-roll linkages. The geometry matches stock linkage points to preserve leverage and bar response while providing predictable articulation under load.

Material selection and socket profile are chosen to minimise binding and to allow controlled pivoting during roll events. These parts are intended for regular service replacement and setup experimentation where consistent joint behaviour is required.

Installation is performed at component level: extract the worn ball end, locate the replacement ball into the socket, and secure using the vehicle's original linkage fasteners. Confirm smooth rotation and clearance from adjacent suspension parts after reassembly.

What tolerances should I expect from these replacements?

Manufactured to match stock Savage 21 linkage clearances, expect minimal runout and consistent pivot with normal servicing intervals.

How do these behave under repeated high-load cycles?

Plastic joints will show gradual wear under heavy duty use; monitor for increased play and replace as part of routine maintenance to retain handling precision.

Are any setup changes recommended after fitting?

Verify anti-roll bar clearance through the suspension travel range and perform small incremental adjustments when tuning to maintain predictable roll balance.