HPI Bullet 3.0 MT/ST Precision Graphite Radio Tray GBMT014B by GPM  [GBMT014B]

Precision radio tray for Bullet 3.0 MT/ST platforms

This graphite radio tray is a replacement panel manufactured to fit the HPI Bullet 3.0 MT and ST chassis configured with Nitro engines. The component provides a stable mounting platform for receiver and servo assemblies while maintaining neat signal and power wiring within the radio bay layout used on these models.

The tray uses a graphite base with a blue finish and is produced to the original radio bay mounting pattern for Bullet 3.0 MT and ST. The design focus is rigidity and a low profile so the panel integrates with typical 1/10 off-road component positions without affecting chassis clearance.

Assembly guidance: the tray is supplied as a single unit and installs using the chassis existing screw points where compatible. Ensure antenna and power lead routing follows stock paths, and verify servo and fuel tank clearance in Nitro-equipped layouts before final torque to avoid mechanical interference.

Service and setup advantage: the tray keeps radio components precisely located for consistent setup comparisons, and simplifies receiver or servo replacement during routine maintenance while preserving the primary chassis geometry.