HPI Bullet 3.0 MT/ST Front Tire and Beadlock Rim Set BMT1003F+889 by GPM  [BMT1003F+889]

Front wheel and beadlock assembly for HPI Bullet 3.0 MT/ST

This aftermarket set supplies front rubber tires mounted on nylon rim frames fitted with alloy 10-pole beadlock rings and includes 12x9mm drive adapters for HPI Bullet 3.0 MT and ST nitro chassis. Components are offered as direct replacements to recover steering feel and enable controlled front-end setup adjustments while retaining the original hub geometry.

Installation requires removal of the stock front wheels, placement of the 12x9mm drive adapters onto the existing hex or axle interface, seating the tyre onto the nylon rim, and securing the alloy beadlock with the provided hardware. Confirm adapter sizing prior to final assembly to ensure correct engagement.

The beadlock configuration allows repeatable tyre seating and minor stagger tuning while the nylon rim frames reduce impact vulnerability. The alloy 10-pole ring clamps the tyre for reliable retention and steadier steering response on mixed surfaces. Inspect fasteners and adapter fit after initial runs and as part of routine maintenance.

Recommended for replacing worn front tyres or for controlled setup trials on HPI Bullet 3.0 MT/ST nitro vehicles; follow measured tightening and periodic checks to preserve hex and rim integrity.