HPI Bullet 3.0 MT/ST Damper Mount Upgrade BMT028 by GPM  [BMT028]

Precision alloy damper mounts engineered for HPI Bullet 3.0 MT and ST

This front and rear alloy damper mount kit replaces the original plastic mounting points and adds integrated body posts for HPI Bullet 3.0 MT and ST platforms. The component set is intended to stiffen the shock tower to chassis interface, providing a more consistent mounting reference during suspension setup and maintenance.

Installation follows standard replacement procedures: remove the factory mounts and secure the alloy units with the existing Bullet 3.0 hardware. After fitting, confirm fastener torque and verify full suspension travel to avoid interference with the chassis or shock shafts.

Workshop note: reducing flex at the shock attachment reduces variables when adjusting rebound, spring rate or mounting position, which helps deliver repeatable ride height and body roll characteristics under nitro truck conditions.

The alloy damper mounts offer a durable upgrade path for Bullet 3.0 MT and ST owners who prioritise reduced mount flex and improved setup repeatability.