GPM BMT160A/ST Spring Steel Adjustable Tie Rods for HPI Bullet 3.0 MT ST Technical  [BMT160A/ST]

Precision-Grade Adjustable Tie Rods for HPI Bullet 3.0

The GPM Spring Steel Front and Rear Adjustable Tie Rods are engineered for precise steering setup on HPI Bullet 3.0 MT and ST platforms. Using resilient spring steel and alloy end fittings, these rods allow accurate toe adjustments while resisting deformation under load.

Technical Highlights

• Material: Spring steel provides high yield strength and better fatigue resistance compared with standard rod stock.
• Adjustability: Offers a range of 73mm-80mm at the front and 78mm-85mm at the rear, providing precise control over vehicle handling.
• Anti Cross-thread Design: Thread geometry is engineered to reduce cross-threading during assembly and repeated adjustments.
• Alloy Ends: Alloy end fittings are specified to maintain secure ball end seating and alignment under dynamic loads.

Application and Fitment

These tie rods suit builders and shippers who prioritise reliable steering geometry and straightforward tuning. They integrate with stock HPI Bullet 3.0 steering link points and support common setup adjustments for track or offroad use.

Packing includes

• Spring Steel Front Adjustable Tie Rod – 2pcs
• Spring Steel Rear Adjustable Tie Rod – 2pcs
• Alloy Ends – 2pcs

Original Name / Part No:

HPI Bullet 3.0 Mt And St Spring Steel Front + Rear Adjustable Tie Rod With Alloy Ends (4mm Anti Cross-thread, To Extend 73mm-80mm & 78mm-85mm) - 6pcs set - GPM BMT160A/ST