HPI Bullet 3.0 MT and ST Front beadlock wheel assembly BMT0503F+889 by GPM  [BMT0503F+889]

Front beadlock wheel assembly

This front wheel and tyre assembly is engineered for HPI Bullet 3.0 MT and ST nitro chassis. Rubber front tyres are mounted on nylon rim frames secured by alloy 5-star beadlock rings, with 12x9mm drive adapters supplied to mate with the specified HPI stub axle interface. The product is provided as a one-pair front set intended for accurate replacement or a targeted front-end upgrade.

Installation follows conventional beadlock procedure: separate the beadlock ring, seat the tyre on the rim frame, align the ring and evenly secure the fasteners. The included 12x9mm drive adapters are designed to interface with Bullet 3.0 hubs; confirm spline orientation before final torque. Recommended checks include even bead seating, static wheel balance, and verifying minimal runout at operational speeds.

From a performance perspective this assembly affects initial turn-in characteristics and front traction. The rubber compound gives consistent grip on mixed off-road surfaces while the alloy beadlock ring increases lateral stiffness of the wheel assembly. The nylon rim frame reduces peripheral mass relative to fully metal wheels, which can change steering feel and may necessitate minor suspension or toe adjustments to reestablish handling balance.

Use as a direct front replacement or as part of front-end setup changes for HPI Bullet 3.0 MT/ST nitro models; verify adapter orientation and perform wheel balancing after fitment to maintain steering precision.