HPI Bullet 3.0 MT and ST Front Alloy Suspension Arm BMT055 by GPM  [BMT055]

HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055
Price:
USD$19.90
Brand:
GPM
Model:
BMT055
GTIN:
4894538028584
Condition:
Brand New
Write a review
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"
alt="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055" title="HPI Bullet 3.0 Mt And St Alloy Front Suspension Arm - 1pr set - GPM BMT055"

Alloy front suspension arm engineered for Bullet chassis

This front suspension arm uses an alloy construction for application on HPI Bullet 3.0 MT and ST chassis, offering a direct replacement for the stock front arm. It is supplied as a 1pr set for hobby nitro buggy applications and is intended for maintenance, repair, and suspension setup work.

Installation needs standard RC tools such as hex drivers; existing mounting pins and ball studs are normally reused unless worn or damaged. The alloy increases structural stiffness relative to typical plastic arms, which can influence steering feedback and suspension response and should be accounted for during tuning adjustments.

Specifications

  • Item Front suspension arm, 1pr set
  • Material Alloy
  • Model Number BMT055
  • Compatibility HPI Bullet 3.0 MT and ST (Nitro Engines)

Targeted at hobbyists seeking a durable front-arm upgrade, this alloy component suits the HPI Bullet 3.0 MT and ST platform for repair or tuning tasks; confirm steering linkage and mount hardware compatibility before full use.

How does alloy stiffness affect suspension tuning?

Increased arm stiffness reduces flex under load, which can sharpen steering response and alter load transfer; expect to fine tune toe, camber, or damping to restore the desired handling balance.

Are original mounting pins compatible with this arm?

Original mounting pins and ball studs are typically compatible and reusable if they are in good condition; replace any worn components to ensure proper alignment and secure mounting.

What inspection steps do you recommend after fitting?

Perform a visual inspection of mounts and fasteners, verify steering travel and linkage clearance, and recheck torque on all fasteners after an initial short running session.