Graphite Radio Tray GBMT014MC for HPI Bullet 3.0 MT and ST by GPM  [GBMT014MC]

HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC
Price:
USD$10.90
Brand:
GPM
Model:
GBMT014MC
GTIN:
4894538066340
Condition:
Brand New
Write a review
alt="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC" title="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC"
alt="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC" title="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC"
alt="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC" title="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC"
alt="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC" title="HPI Bullet 3.0 Mt And St (Nitro Engines) Graphite Radio Tray - 1pc - GPM GBMT014MC"

Precision-fit graphite radio tray overview

This graphite radio tray is an aftermarket upgrade for HPI Bullet 3.0 MT and ST nitro chassis. It provides a low-profile, stiff platform for receiver, servo and small electronics while supporting organised cable routing. The sections below detail compatibility, fitting guidance and tuning considerations for hobbyists.

Compatibility and role: the tray is intended to replace the standard radio platform on Bullet 3.0 MT and ST nitro chassis to deliver improved mounting rigidity and a tidy electronics bay. The firmer surface reduces movement of the receiver and servo connectors during heavy use, aiding consistent steering input and radio performance.

Installation notes: the tray aligns with the original mounting points so installation normally uses existing screw locations and hardware. Inspect screw length and thread before final fitting, route antenna and servo leads to avoid sharp bends or pinching, and confirm there is no interference with fuel tank or exhaust routing on nitro setups.

Tuning considerations: fitting a graphite tray alters local chassis stiffness and can change feedback through the steering. After fitting, prioritise verifying radio and servo stability, then adjust suspension or ballast if handling characteristics require tuning.

What should I check for during test fit?

Check that mounting holes align, screws engage correctly without bottoming out, and that the tray clears fuel tank and exhaust routes. Verify antenna and servo lead routing for no pinch points.

Will the tray change chassis feedback?

Graphite increases local stiffness beneath the radio area, which can result in a subtle change to steering feel. Evaluate radio stability first, then tune suspension or weight distribution if necessary.

Any recommendations for securing wiring?

Use small cable ties or clips to keep servo leads and antenna routed cleanly, avoid sharp bends near screw heads, and check routing after initial runs to ensure nothing has shifted.