GPM SW088X 88mm Aluminium Internal Shocks for Gmade GS01 Sawback  [SW088X]

Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X
Price:
USD$18.90
Brand:
GPM
Model:
SW088X
GTIN:
4894538010039
Condition:
Brand New
Write a review
alt="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X" title="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X"
alt="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X" title="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X"
alt="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X" title="Gmade 1/10 Gs01 Sawback 4WD Vehicle Aluminium Front/Rear Internal Shocks (88mm) With Engraving- 1pr set (For KOmodo / Sawback) - GPM SW088X"

Precision Aluminium Shocks for Gmade GS01 Sawback

The GPM SW088X aluminium internal shock set is developed to provide a more consistent suspension response on Gmade 1/10 GS01 Sawback platforms, and is also compatible with KOmodo chassis. The 88mm length and engraved bodywork support neat assembly and stable performance under varied driving loads.

Technical Highlights

  • Material: Durable aluminium bodies designed for reduced flex and reliable service life
  • Compatibility: Engineered to match Gmade 1/10 GS01 Sawback and KOmodo geometry
  • Length: 88mm to maintain intended travel and ride height
  • Design: Internal shock configuration with engraved detailing for accurate fitment

Installation and Use

These shocks are intended as a direct upgrade to standard dampers on supported platforms. Fitment follows standard mounting conventions and allows straightforward tuning via shock oil and spring selection to suit track or trail conditions.

Compatible Models

  • Gmade 1/10 GS01 Sawback
  • KOmodo

What setup steps are recommended after fitting SW088X?

Confirm correct mounting orientation, fill shocks to the preferred oil level, and perform a baseline test run to check ride height and damping before fine tuning.

How should I approach damping changes with these shocks?

Adjust oil viscosity and spring rate incrementally; start with a medium weight oil and assess rebound and compression through controlled runs to determine the right balance.

Are spare service parts recommended for long term use?

Keeping spare seals and spare shafts is advisable for routine maintenance, especially if you run frequently in abrasive or wet conditions.