Axial Yeti XL Precision Steel#45 20T Differential Gear YTL1202S/G3 by GPM  [YTL1202S/G3]

Axial Racing Yeti XL Steel#45 Differential Gear 20T - 2pcs - GPM YTL1202S/G3
Price:
USD$15.90
Brand:
GPM
Model:
YTL1202S/G3
GTIN:
4894538213300
Condition:
Brand New
Write a review

Precision 20T Steel#45 differential for Yeti XL service

The YTL1202S/G3 is a Steel#45 20-tooth differential gear produced for compatibility with the Axial Racing Yeti XL. It is intended as a direct replacement or service part to restore accurate gear mesh and tooth form within the original diff assembly.

Fitment requires confirmation of tooth count and face alignment. Set mesh using a marking compound and adjust shim stack or carrier spacing to achieve uniform contact across the tooth face. Apply thread locking to retaining fasteners only where specified by the vehicle manual and verify bearing endplay to prevent preload that could accelerate wear.

Specifications

  • Item Differential Gear 20T - 2pcs
  • Material Steel#45
  • Model Number YTL1202S/G3
  • Compatibility Axial Racing Yeti XL

Choose this matched Steel#45 pair to maintain correct tooth geometry and improve drivetrain durability during routine service or component replacement on the Yeti XL chassis.

How do I verify tooth profile accuracy after installation?

Use a gear marking compound to check contact across the tooth width while rotating the drivetrain by hand. A centered contact patch indicates correct profile and spacing.

What tolerance controls should I check on the differential assembly?

Inspect bearing fit for axial play, confirm carrier plate alignment and measure backlash to ensure it falls within the chassis specification to avoid premature wear.

Are there recommended installation practices to maximise service life?

Ensure clean assembly surfaces, apply appropriate grease to gear faces, torque fasteners to spec, and perform a short break-in with subsequent mesh recheck to stabilise contact patterns.