Axial Yeti precision anti-thread tie rod 5pc YT160S by GPM  [YT160S]

Precision tie rod assembly for Axial Yeti

This engineered 5pc tie rod assembly is intended for Axial Racing Yeti platforms and supplied for maintenance, rebuild and tuning tasks. Each centre shaft is spring steel for enhanced resilience to bending, while machined aluminium end fittings provide consistent interface geometry with steering knuckles and hub carriers. The component is designed for hobby-grade RC use and workshop service routines.

Functionally the assembly replaces worn or damaged tie rods to restore steering geometry and secure thread engagement, reducing the risk of stripped threads at the rod ends. Intended fitment targets Axial Yeti chassis variants; verify linkage lengths and end-fit style prior to installation. The set is suited to applications where repeatable steering geometry and reliable thread retention are required during tuning and maintenance.

Installation uses standard RC workshop methods: remove the wheel, access the steering linkage, match lengths, transfer ball cups or set turnbuckles to original geometry, then torque hardware to recommended levels. Inspect ball cups and servo-saver interfaces for wear when replacing tie rods to ensure a complete and dependable steering assembly.

Use this precision 5pc set when restoring steering geometry or when carrying out measured tuning changes on Axial Yeti models; confirm fitment and secure all fasteners before operation.