Axial Yeti Precision Aluminium Rear Cage Mount YT311A by GPM  [YT311A]

Precision aluminium rear cage mount

This aluminium rear cage mount is an aftermarket replacement for the Axial Racing Yeti platform, intended to restore or reinforce the rear cage fixing points on the rock racer. The design targets a direct-fit installation where chassis rail spacing and mounting bushings match the Yeti cage geometry.

The component provides a stiff interface between the rear cage and chassis rails to reduce movement under load and preserve body mount alignment during demanding use. Aluminium construction offers improved wear resistance over typical plastic mounts and helps maintain alignment after impacts.

Installation follows common replacement procedures: remove existing rear cage mount hardware, test-fit the aluminium part to confirm hole alignment, then secure with the original screws or appropriate equivalents. Verify thread engagement and apply thread locker in line with your maintenance practices. Standard hex drivers are sufficient for trial fitting and final assembly.

In tuning applications this mount gives repeatable rear cage location for suspension and body setup adjustments; it should be used as part of measured setup changes rather than to cover other structural faults in the chassis.