Axial Wraith Precision 6x160.2mm Steel Straight Axle Shaft SWR238L by GPM  [SWR238L]

Precision replacement shaft for Wraith axles

This single-piece 6x160.2mm steel straight axle shaft is supplied as SWR238L and sold as 1pc for use with the Axial Racing Wraith axle assembly. The component is engineered to match axle length and seating dimensions so the chassis geometry remains unchanged when replaced.

Designed for maintenance and service, the shaft replaces bent or worn originals and supports consistent drivetrain alignment. Installation requires axle disassembly to remove the existing shaft, fitting the replacement into the axle housing and confirming correct seating of bearings, pins and retaining hardware.

For setup verification, fit the SWR238L shaft to restore nominal axle length, then measure wheel runout and driveline alignment. Recheck bearing fit and retention after an initial break-in to ensure long term reliability in trail and technical driving conditions.