AXIAL SMT10 Precision Aluminium Wheel Hex +2mm MJ0104/+2MM by GPM  [MJ0104/+2MM]

Precision aluminium wheel hex, SMT10 +2mm offset

This precision machined aluminium wheel hex is an aftermarket upgrade intended for AXIAL Racing SMT10 wheel assemblies. Supplied as a set of four, the component provides a +2mm lateral offset to address clearance or stance requirements while retaining original wheels and hubs. The design focuses on fit accuracy and stable mounting within the wheel assembly.

Fitment follows conventional procedures: remove the wheel and stock hex, locate the aluminium hex onto the axle or hub with correct orientation relative to the chassis, then resecure wheel hardware. After assembly, validate wheel clearance through the full travel range and confirm that drive pins and screws are torqued and locked to avoid loosening during operation. The component utilises machining-grade aluminium for consistent geometry and long term service as a mounting element.

The package also contains common hardware to complete installation, included exactly as supplied:

• 2x10.9 Steel Pin - 4pcs
• 2x7 Steel Pin - 4pcs
• 2.5x2.5 Screw Shaft - 8pcs
• 1.2 Hex Socket Key - 1pc