AXIAL SMT10 Precision Aluminium Front/Rear Axle Housing MJ012 by GPM  [MJ012]

Precision front and rear axle housings for SMT10 platforms

This precision aluminium front and rear axle housing is engineered for AXIAL SMT10 vehicles to accurately position axle assemblies and provide consistent mounting for drivetrain bearings and shafts. The component targets improved structural stiffness and serviceability in scale short-course and trail builds.

Installation requires controlled disassembly of the axle and gearbox area, verification of bearing bores, and torque to specified values. The housings are intended to replace fatigued plastic units, restoring alignment and improving longevity under load when paired with correct bearing selection.

During fitment confirm inner bearing diameters, verify shaft seating tolerances, inspect for adequate clearance across suspension travel, and ensure driveshaft engagement with the gearbox output. Perform measured setup validation and monitor wear patterns during initial testing.

Use these aluminium housings for targeted drivetrain upgrades on AXIAL SMT10-scale models to enhance alignment and bearing support; confirm all mating dimensions before assembly.