AXIAL SCX30 Brass Centre Gear Box Mount Skid Plate 18g SCX30/38X by GPM  [SCX30/38X]

Brass centre mount for SCX30

This RC-scale replacement center gear box mount skid plate is machined from solid brass for AXIAL SCX30 platform models. The 18g brass billet is intended to replace the factory part AXI-3311 and be mounted at the vehicle centre where the gearbox attaches. It is designed for 1/30 scale crawlers.

At the model level the plate adds concentrated mass to the chassis centreline, which can improve front/rear traction balance and low-speed climb stability on technical rock courses. The supplied hardware set covers common thread sizes used on SCX30 assemblies and allows a direct swap-in with the original mounting locations.

Installation notes: remove the stock centre mount, fit the brass plate to the same screw bosses, and use the supplied round head screws. Use a correctly sized hex driver and hand-tighten to seat, then final snugging is advised to avoid stripping small threads. Verify clearance to suspension and driveline before full operation.

For AXIAL SCX30 1/30 scale rock crawlers this brass centre mount provides a simple aftermarket upgrade to alter vehicle balance and improve low-speed traction; confirm fit and torque hardware carefully during installation.