AXIAL SCX10 III Precision CVD Drive Shaft Set SCX3L037SA by GPM  [SCX3L037SA]

Precision CNC style CVD shafts for SCX10 III JT

This front and rear CVD drive shaft assembly is engineered for AXIAL Racing SCX10 III JEEP JT GLADIATOR platforms. The mixed-material layout uses alloy 6061 T6 components mated with hardened steel internal parts to balance torsional stiffness and wear resistance while keeping realistic scale mass. The CVD swing joint design sustains even torque transmission through large suspension articulation seen on 1/10 scale crawlers.

Installation notes: these shafts replace stock dogbones or plastic drive elements and mount to axle hex outputs and CVD-capable transmission interfaces. Confirm axle hex clearance, align splines and retain with the supplied screw pins. Apply thread locker sparingly to steel fasteners only where required and cycle the suspension to confirm full rotational clearance before final torqueing.

Tuning considerations: upgrading to alloy 6061 T6 with steel mating surfaces improves torque handling and reduces driveline lash for finer low speed control. During installation inspect spline engagement, wave shims and bearing condition to ensure the entire drivetrain is ready for increased loads.

This GPM-produced CVD drive shaft set is specified for hobbyists wanting a precision upgrade to AXIAL SCX10 III JEEP JT GLADIATOR drivetrains; verify fit before completing installation.