Axial SCX10 II Precision Steel Gear Shaft SCX27038SG by GPM  [SCX27038SG]

AXIAL Racing SCX10 II Steel Transmission Gear Shaft - 1set (For SCX10 90037, SCX10 Ii 90047, Smt10 90055, 90057) - GPM SCX27038SG
Price:
USD$14.90
Brand:
GPM
Model:
SCX27038SG
GTIN:
4894538263596
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

GPM Steel Transmission Shaft for Axial SCX10 II

This steel transmission gear shaft is offered as a single replacement set for Axial SCX10 II platforms, engineered for accurate fitment where compatibility is specified. It is intended to restore correct drivetrain alignment and mechanical performance without altering the original gearbox geometry.

Technical fitment notes: remove the necessary axle or gearbox cover, reuse compatible spacers and bearings from the original shaft where serviceable, seat the new shaft to specification and verify even gear mesh plus correct bearing preload. This is a mechanical drivetrain component intended for maintenance, repair or setup refinement on compatible SCX10 models.

Compatible Models

  • SCX10 90037
  • SCX10 Ii 90047
  • Smt10 90055
  • 90057

How to verify correct fitment?

Confirm your chassis code against the compatible models list, then dry-fit the shaft to check bearing seats and axial clearance before final assembly.

Recommended bearing handling?

Inspect bearings for wear, clean raceways and lightly lubricate seals if present; replace bearings showing pitting or excessive play to maintain drivetrain reliability.

Post-installation validation steps?

Perform low-speed rotational checks, verify consistent gear engagement under light load and re-torque mounting hardware after an initial run-in period.