Axial RR10 Steel Bevel Gear Set RR1200S Technical Replacement Pair by GPM  [RR1200S]

Axial Racing RR10 Bomber Steel Front/Rear Bevel Gear - 2pcs (For RR10 Bomber / Yeti / Wraith) (AX30392)- 2pcs - GPM RR1200S
Price:
USD$23.90
Brand:
GPM
Model:
RR1200S
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Steel replacement bevel gears for RR10 axles

The RR1200S is a two-piece steel bevel gear set intended for front and rear axle duties on the Axial models listed in the compatibility box. Supplied as 2 pcs, the set is intended to replace stock bevels where steel construction is preferred for durability and sustained service under load.

Use this set when replacing worn bevels or when reinforcing a drivetrain for heavier scale crawling or trail use. These components transmit torque between perpendicular shafts inside the axle or gearbox and are supplied to match original bevel geometry for direct swap fitment where compatible.

Service notes: remove the axle or gearbox cover to access bevels, inspect matching gears and bearings for wear, set gear mesh and axial alignment precisely during installation, and apply suitable gear grease before running. Confirm smooth free rotation and check for any irregular noise during a low-speed test before normal operation.

Compatible Models

  • RR10 Bomber
  • Yeti
  • Wraith

A two-piece steel bevel gear replacement for Axial RR10-based drivelines where wear resistance is required, supplied for front and rear applications.

What checks are recommended before installing RR1200S bevels?

Inspect axle housings, mating gear faces and bearings for wear or damage, verify spline and bore dimensions, and ensure there are no previous modifications that could affect fitment.

How should gear mesh be set for these steel bevels?

Set axial position to achieve full tooth contact without tight spots, verify by hand rotation, then perform a low-speed powered check while monitoring for binding or uneven wear.

Are any additional parts commonly replaced at the same time?

It is common practice to inspect and, if necessary, replace worn bearings, pinions or seals to ensure correct mesh and to protect the new steel bevels from premature wear.

What post-install checks should be done on RR1200S gears?

After assembly, verify smooth free rotation, run a short low-load break-in, recheck mesh and fasteners, and confirm there are no unusual noises under load.