Axial RR10 Bomber RR030 Aluminium Rear Shock Mount Technical Upgrade by GPM  [RR030]

Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030
Price:
USD$20.90
Brand:
GPM
Model:
RR030
GTIN:
4894538218657
Condition:
Brand New
Write a review
alt="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030" title="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030"
alt="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030" title="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030"
alt="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030" title="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030"
alt="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030" title="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030"
alt="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030" title="Axial Racing RR10 Bomber Aluminium Rear Shock Mount - 1pr set - GPM RR030"

Precision aluminium rear shock mount for RR10 Bomber

The RR030 is an aluminium rear shock mount supplied as a 1pr set designed for direct replacement on the Axial RR10 Bomber when original mounting geometry is unchanged. It provides a rigid mounting surface engineered to interface with the Bomber rear suspension arrangement while maintaining factory fit where hole locations match.

As a structural component, the mount fixes the rear shocks and transmits forces into the chassis and shock tower. Installers should perform standard rear-end disassembly and ensure precise alignment of the shock eye and tower mounting holes before final fastener torqueing. This description omits specific tooling guidance.

From a tuning perspective, the reduced compliance of an aluminium mount can alter effective shock angle and feedback compared with flexible plastic mounts. Use the RR030 as part of a controlled setup procedure, adjusting rebound, spring rate, or mounting position incrementally to evaluate dynamic changes on the RR10 Bomber.

Specifications

  • Item: Rear shock mount, 1pr set
  • Material: Aluminium
  • Model Number: RR030
  • Compatibility: Axial Racing RR10 Bomber

Specify the RR030 when a dimensionally stable rear shock interface and consistent setup feedback are required for precision hobby use.

What tolerance checks should I perform during fitment?

Verify hole concentricity and thread engagement, and cycle suspension travel to check for binding before final torqueing to ensure correct fit and repeatable geometry.

Will this change dynamic response under load?

Yes, reduced mount compliance typically produces crisper shock response; quantify changes by comparing telemetry or consistent test runs and adjust damping progressively.

Recommended inspection intervals?

Inspect fasteners and mating surfaces after the first few runs and as part of routine maintenance after heavy use to detect any thread wear or loosening.

Is any post-install shimming or packing usually required?

When the replacement preserves original hole positions, additional shimming is rarely needed; if slight clearance differences are observed, minor shims can be used to maintain correct shock angle without altering mount geometry.