AXIAL Racing SCX10 II Precision Aluminium Centre Shaft Set SCX2037A by GPM  [SCX2037A]

Engineered aluminium centre shafts for SCX10 II drivetrains

This front and rear centre shaft assembly is produced for AXIAL Racing SCX10 II platforms and identified as model SCX2037A. The components use CNC-ready aluminium shaft sections combined with a hardened steel joint to optimise rotational mass reduction and coupling durability for crawler duty.

The kit includes two length ranges: short (S:100mm-107mm) and long (L:135mm-142mm), supplied as a single replacement set. Aluminium shaft sections lower inertial load on rotating parts while the steel joint concentrates wear resistance at the coupling interface, improving service life under slow-speed torque conditions.

Installation follows standard SCX10 II procedures and uses the included screws and O-rings to clamp and seal the joints. Technically, the lighter shaft assemblies reduce drivetrain inertia and can deliver smoother rotational response during precise crawling, subject to final gearing and motor choice.

Designed for precision hobbyists seeking reduced rotating mass with a durable coupling solution; verify shaft lengths and torque screws to recommended values during fitting.