ARRMA MINI KRATON 3S Front Skid Plate 1mm MAKM330F by GPM  [MAKM330F]

ARRMA MINI KRATON 3S Stainless Steel Front Chassis Skid Bumper Thick 1mm - GPM MAKM330F
Price:
USD$12.90
Brand:
GPM
Model:
MAKM330F
GTIN:
4894538412468
Condition:
Brand New
Write a review
alt="ARRMA MINI KRATON 3S Stainless Steel Front Chassis Skid Bumper Thick 1mm - GPM MAKM330F" title="ARRMA MINI KRATON 3S Stainless Steel Front Chassis Skid Bumper Thick 1mm - GPM MAKM330F"
alt="ARRMA MINI KRATON 3S Stainless Steel Front Chassis Skid Bumper Thick 1mm - GPM MAKM330F" title="ARRMA MINI KRATON 3S Stainless Steel Front Chassis Skid Bumper Thick 1mm - GPM MAKM330F"

Front stainless skid bumper overview

This stainless steel front chassis skid bumper is a direct aftermarket replacement designed for 1/16 ARRMA MINI KRATON 3S models. It is formed from 1mm stainless steel to provide a flat, rigid bearing surface where the front of the chassis meets obstacles and the ground. The part focuses on damage mitigation and preserving the chassis edge during short-course and backyard running.

Fit and function: the plate mounts to the vehicle's front chassis plate to reduce wear on the original molded bumper and to offer a predictable contact surface when scraping or hitting ruts. Its rigidity helps transfer impact loads to the chassis mounting points rather than to plastic components.

Installation notes: basic disassembly of the front bumper area is required to fit the steel plate. Use the original mounting holes and supplied hardware where applicable, verify screw length and thread engagement, and check clearance for steering and suspension travel after installation. Tighten fasteners securely but avoid over-torquing to prevent thread damage.

Compatible Models

  • ARRMA 1/16 MINI KRATON 3S DSC 4X4 RTR Brushless Speed Truck-ARA2508S
  • ARRMA 1/16 MINI KRATON 3S DSC 4X4 RTR Brushless Speed Truck-ARA2508

Is this skid bumper suitable for both ARA2508 and ARA2508S chassis codes?

The plate is compatible with the ARRMA 1/16 MINI KRATON 3S variants listed in the compatible models box; always check the chassis model identifier before purchasing to confirm match.

Can I use the truck's original bumper screws to install the plate?

If the original screws line up and engage correctly, they can be reused. Otherwise, select screws that match the chassis thread and required length, and ensure they are strong enough for impact loading.

Should I expect any steering interference after fitting?

After installation, move the wheels to full lock and cycle the suspension to check for any contact. Some setups may need slight plate repositioning or minor trimming to avoid interference.