ARRMA KRATON 8S BLX Front Gear Box MAKX012 Direct-Replace Kit by GPM  [MAKX012]

Aluminium front gear box overview

This aluminum front gear box is an RC-scale replacement housing intended for ARRMA KRATON 8S BLX installations, designed to stabilise front differential components, dampers, anti-roll bar linkages and knuckle arms. The part is offered as a 32pcs set of components for assembling the front gearbox assembly on the model platform referenced in the product title.

The unit is manufactured from 6061 T6 aluminum to provide higher tensile strength than typical plastic housings, with tighter machining tolerances to reduce internal clearance and promote consistent steering response. The material choice also helps dissipate heat generated around the front differential area during extended runs.

Installation requires disassembly of the stock front gearbox and transfer of internal gears and bearings into the new aluminum housing, followed by reattaching the supplied fasteners in the correct sequence. The kit includes a full complement of screws and shafts to replace the original plastic fasteners where applicable, allowing a direct swap on compatible ARRMA parts listed under Original Name / Part No.

For hobbyists seeking a stiffer front end and reduced housing flex on ARRMA KRATON 8S BLX models, this aluminum front gear box provides a direct-replacement approach that focuses on mechanical stability and thermal advantages of metal over plastic housings. Follow standard RC assembly practices and verify fastener torque after initial runs.