Alloy Rear Knuckle Arm Holder +0.2mm Toe MZA031R/+0.2 by GPM  [MZA031R/+0.2]

Kyosho Mini-Z AWD Alloy Rear Knuckle Arm Holder (Toe In +0.2mm) - 1pc - GPM MZA031R/+0.2
Price:
USD$3.20
Brand:
GPM
Model:
MZA031R/+0.2
GTIN:
4894538121513
Condition:
Brand New
Write a review
Precision alloy rear knuckle arm holder for MR-03 AWD Mini-Z to set a controlled +0.2mm rear toe, model MZA031R/+0.2. by GPMAlloy Rear Knuckle Arm Holder +0.2mm Toe MZA031R/+0.2 by GPM

Precision alloy rear knuckle mount for Mini-Z AWD

This alloy rear knuckle arm holder is engineered for MR-03 AWD compatible Mini-Z layouts to deliver a fixed +0.2mm rear toe correction. It functions as an aftermarket tuning component to refine rear alignment without replacing primary suspension elements.

The design shifts knuckle mounting geometry to modify rear toe response, aiding turn-in and mid-corner stability while remaining a direct-replacement part on compatible setups. Installers should confirm fit and retorque fasteners after test runs.

Compared with standard plastic mounts, the alloy option reduces flex at the knuckle interface and helps maintain toe settings under load during club sessions or practice. Use this part for precise handling adjustments.

What handling change does +0.2mm toe produce?

A small toe-in bias reduces rear yaw and can stabilise corner exit and mid-corner balance, offering a measured change for setup tuning.

Is fitment standard across MR-03 AWD variants?

The holder is designed for MR-03 AWD compatible layouts; verify your chassis mount points for compatibility prior to fitting.

Recommended post-fit checks?

Confirm alignment and toe after installation, then recheck fastener torque after a brief running session to ensure consistent performance.